Posted by sabro on March 21, 2003 at 04:00:26:
I may have gotten rid of the grinding marbly sound in my engine. (Which turned out to be pretty bad- the output shaft, pulley assembly was very loose).
Well, my bike is almost back on the road after a long winter wait. I bought an engine from sojudave- which turned out to be spraypainted blue and black. Stripped the paint (and the clear aluminum coating) off and swapped out my gravelly engine.
It idles great, but when given gas it just about chokes, sputters, pops, and dies. Sounds super lean.
Tomorrow I'll try to figure out how to set the carb mix/jetting. It didn't look to familiar or obvious to do, since there seems only to be an idle screw, and nothing else. Any Suggestions?